In order to meet ASTM safety standards, a closed cover should have a cover pump in place on top of the cover to remove any accumulated water.However, do not use laundry detergent or any other chemicals to clean the cover. To remove this build-up and other debris, wash the cover with a mild hand dish washing liquid every 3-6 months. The sun then dries it, causing high concentrations of chlorine on top of the cover that may damage the fabric. When you uncover the pool, the water in the pool is transferred from the pool to the top surface of the cover.If the cover is closed before the chemicals have had a chance to mix, this could shorten the life of the fabric or not allow the chemicals to balance properly in the pool. If you are unsure if it is safe to close the cover, test the water at the surface with your test kit. After adding any chemicals to your pool, allow the chemicals to circulate before closing the cover. The general rule is that you only cover a pool that you would swim in. Doing this will minimize the harmful effects of chemical imbalance. It is also important to monitor the chemistry of the pool water and keep it properly balanced.By simply maintaining your water level, it will help keep your system running smoothly. If the water level in the pool is too low to support the weight of the snow load, significant damage can occur to the pool and pool cover. It is critical to maintain the correct water level especially in the winter months if the cover is being used as a winter cover. If the water level is too low, the cover will have a lot more sag in it, which adds more stress and wear to the system. If the pool is overfilled, water can flow over the bond beam into the housing and flood the mechanism.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |